10
TASCAM CD-9010
2 – Names and Functions of Parts
g
WORD SYNC IN
Input a word clock signal through this connector. When
this unit is set to use an external clock (EXT), the word clock
input through this connector is used.
h
75Ω (ON/OFF) switch
Turns the 75Ω word clock terminator ON or OFF.
j
POWER switch
Turns the power ON or OFF.
CAUTION
Before turning on the power, turn down the volume of other
equipment connected to this unit. Failure to do so might cause
sudden loud sounds, which could harm your hearing or result in
other trouble.
k
AC IN connector
Connect the included power cord here.
l
REMOTE (PARALLEL)
This D-sub 37-pin I/O connector is for parallel control.
Use it for external control, including fader starting. (See
"Using the parallel connector" on page 35.)
;
REMOTE (SERIAL)
This D-Sub 15-pin I/O connector is for serial control.
Connect a TASCAM RC-9010/RC-9010S remote control (sold
separately) here.
Rear panel
o
DIGITAL OUTPUT (COAXIAL)
This outputs a digital CD playback signal. The digital output
signal depends on the
DIGITAL OUT TYPE
setting on the
SYSTEM
menu screen. (See "Setting the digital output format"
on page 29.)
The digital output signal depends on the master clock
setting. (See "Setting the master word clock" on page 30.)
p
DIGITAL OUTPUT (XLR)
This outputs a digital CD playback signal. The digital output
signal depends on the
DIGITAL OUT TYPE
setting on the
SYSTEM
menu screen. (See "Setting the digital output format"
on page 29.)
The digital output signal depends on the master clock
setting. (See "Setting the master word clock" on page 30.)
a
MONITOR OUTPUTS (R/L) (unbalanced)
These unbalanced RCA analog outputs can be connected to
a monitoring system.
The nominal output level is –10 dBv.
s
LINE OUT OUTPUTS (R/L) (balanced)
These are balanced analog XLR outputs.
The default nominal output level is +4 dBu (+6 dBu only
when the maximum output level is +15 dBu), but can be set
to –20 dBu.
(1: GND, 2: HOT, 3: COLD)
d
MIX INPUTS (R/L) (balanced)
These balanced analog XLR inputs are used for mix input
with a nominal output level of +4 dBu.
(1: GND, 2: HOT, 3: COLD)
Signals input here are mixed with the playback signal from
the CD and output from the LINE OUTPUTS. Even when the
power is off, signals input here will be output unchanged
through the LINE OUTPUTS.
f
WORD SYNC THRU
The input word clock signal is thru output from this
connector, allowing it to be sent to other digital devices.
