24
TASCAM CD-9010
5 – Program and cue playback
Program playback
You can create a program in advance to play up to 99 tracks you
want in the desired order.
Program menu operation
Select
PROGRAM EDIT
and press the DATA dial to open the
PROGRAM
screen (program list). Select the desired item, and
press the DATA dial to open the
PROGRAM MENU
pop-up with the
following options.
ADD PROGRAM
Adds the highlighted track to the program.
DELETE ALL PROGRAM
Removes all tracks from the program.
DELETE PROGRAM
Removes the selected program track.
MOVE
Move the selected program track to a different position in the
program order.
CANCEL
Close the
PROGRAM MENU
without conducting any operation and
return to the
PROGRAM
screen.
Adding tracks to a program
Follow these procedures to set up a program.
1. With playback stopped, press the
PLAY MODE
button
and set the playback mode to
PROGRAM
(See "Setting the
playback mode" on page 17.)
2. Press the
MENU
button to open the
MENU
screen.
3. Open the
PROGRAM/CUE
menu.
4. Select
PROGRAM EDIT
.
5. Press the
DATA
dial to open the
PROGRAM
screen.
6. Turn the
DATA
dial to select the number in the program
where a track will be added, and press the
DATA
dial to
open the
PROGRAM
menu.
7. Turn the
DATA
dial to select
ADD PROGRAM
.
8. Press the
DATA
dial to open the
BROWSE (ADD
PROGRAM)
screen.
9. Turn the
DATA
dial to program to select a track, and press
the
DATA
dial to add the track to the program.
10. Repeat steps 6–9 to add more tracks to the program as
desired.
The screen shows the number of tracks in the program
and the total program time
.
NOTES
You can add the same track to the program more than once.
•
You can add a maximum of 99 tracks to a program. If you
•
try to program a 100th track, a PROGRAM FULL warning
message pop-up appears.
If the total time of the programmed tracks exceeds 99 hours
•
59 minutes, 59 seconds, “
- -: - -: - -
” appears on the
display.
A program can only include tracks from one CD. After tracks
•
have been added to a program from one CD, if you try to
add a track using a different CD, a "–Cannot Program–"
message will appear and the track will not be added.
11. When you have finished entering tracks to the program,
press the
HOME
button to return to the Home Screen.
12. Press the
MONITOR
button or
PLAY
button to start
program playback.
NOTES
If you set PROGRAM playback mode but no tracks have
•
been added to the program, the setting will change to
CONTINUE when playback starts.
Program settings are retained even when the power is
•
turned OFF.
If you try to start program playback when a CD that is
•
different from the one used by the program, a “–Can't Play
Program–” message will appear and playback will not start.
