16
TASCAM CD-9010
3 – Preparations
Setting the panel lock function
The unit can be set so that it can only be operated using a
TASCAM RC-9010/RC-9010S remote control (sold separately).
1. Press the MENU button to open the
MENU
screen.
2. Open the
REMOTE
menu screen.
3. Select
OPERATION PANEL
.
4. Press the
DATA
dial to move the cursor (selected area)
right to select the setting.
5. Turn the
DATA
dial to set whether or not you can use the
front panel controls to control the unit.
•
CD+RC
:
The unit can be controlled using a TASCAM RC-
9010/RC-9010S remote control (sold separately) and
the unit's front panel buttons.
•
RC ONLY
(default value)
:
When a TASCAM RC-9010/RC-
9010S remote control (sold separately) is connected,
the unit's front panel buttons (other than the
OPEN/
CLOSE
button) are disabled.
6. After completing the setting, press the
HOME
button to
return to the Home Screen.
NOTE
When a remote is not connected, even when this item is set
•
to RC ONLY, the panel controls will not lock.
To unlock the panel, press the MENU button, while pressing
•
and holding the HOME button. When the “OPERATION PA
NEL Change to CD+RC?” pop-up message appears, select
“Yes” to unlock the panel.
You can also lock the panel controls by pressing the MENU
•
button while pressing and holding the HOME button. When
the pop-up message appears, select “Yes”.
The panel lock function setting is stored even when the
•
power is turned OFF.
