TASCAM CD-GT1MKII —
19
(continued from the previous page)
Split monitor
Setting the split monitor mode allows
you to split the output of the CD and
the guitar into left and right outputs.
Press and hold the
TMP/KEY / CD EFF
key to enter the CD Effect menu, and
select
SPLT
by pressing either the
PREV
or
NEXT
key. Press the
UP
or
DOWN
key to select from the following:
C-G
: outputs the sound of the CD
from the left, and the sound of the
guitar/microphone from the right.
G-C
: outputs the sound of the gui-
tar/microphone from the left, and
the CD sound from the right.
OFF
: outputs stereo mixed sound of
CD and guitar/microphone from
left and right.
Using built-in effects
The top right of the display shows two
effect “banks,” A and B. These two
banks each have five “slots” numbered
from 1 through 5 where you can store
your own effect settings.
Effects are created from the 57 preset
effects available (45 guitar and 12 vo-
cal). Each of the 45 guitar effect presets
has four components, while the vocal
effect presets have only one.
When a bank and slot are selected, if a
preset effect is recalled and edited, that
bank slot is automatically filled with
the edited effect.
Components
DIST
Distortion gain
TONE
Tone control
DRIV
Overdrive gain
COMP
Compressor gain
FLA
Flanger setting
REV
Reverb setting
DLY
Delay setting
PHA
Phaser setting
EXC
Exciter setting
PIT
Pitch shifter setting
CHO
Chorus setting
TRM
Tremolo setting
VIB
Vibrato setting
WAH
Auto-wah setting
Storing your own effect settings
in a bank slot
1. Starting in the home display
mode, press the
FX
BANK
key to
select either the A or B bank.
2. Press the
FX No./EDIT
key to se-
lect the bank slot.
3. Press and hold the
FX No./EDIT
key to open the Effect menu.
4. Select
EFF
by pressing either the
PREV
or
NEXT
key.
5. Press either the
UP
or
DOWN
key
to turn an effect ON or OFF.
6. Press either the
PREV
or
NEXT
key to select
LIB
: (effect preset
library). The display shows a letter
(continued on the next page)
Using built-in effects
