5 - Messages, troubleshooting, etc.
22
TASCAM CD-RW5000
5.1.1 Self-diagnostic program
The CD-RW5000 allows you to check the electronic
components of the unit if you are experiencing prob-
lems in the operations of the unit, and the trouble-
shooting measures described above have not cured
the problem.
1
Eject and remove any disc, and turn off the
CD-RW5000.
2
Press and hold down the
PLAY
and STOP
keys on the main unit (
[15]
and
[14]
) and
keep them pressed while turning the unit
back on again.
3
The display will show the word
BUSY
, in
flashing characters, after a few seconds.
4
After a few minutes, the message will change
to either
ERROR
or
PASSED
.
5
If the
ERROR
message appears, there is a
fault in the CD-RW5000 which must be
repaired by your TASCAM service center.
Do not attempt to repair the CD-RW5000 by
yourself.
6
If the
PASSED
message appears, the prob-
lem is one which cannot be diagnosed by the
program. The problem may be due to any of
the following causes: you are trying to do an
operation which does not correspond to the
instructions in this manual, the disc is of the
wrong type for the operation, the connections
have been wrongly made, or there may be a
fault in the mechanical part of the recorder.
7
Leave the self-diagnostic program by turning
off the power to the CD-RW5000.
