5. Specifications
English
TASCAM CD-X1700 DUAL CD PLAYER
25
Disc type:
8cm / 12cm CD
Number of channels:
2-channel
Resolution:
16-bit
Sampling frequency:
44.1kHz
Analog output:
RCA pin jack
Output impedance:
<1kohm
Maximum output level:
+6dBV
Digital output:
Coaxial
Format:
IEC60958 Type II
Voltage requirements
USA/Canada:
120V AC, 60Hz
UK/Europe:
230V AC, 50Hz
Australia:
240V AV, 50Hz
Power consumption:
30W
Peak inrush current:
0.9A
Applicable electromagnetic
environment:
E4
Dimensions (W x H x D mm)
Main unit:
482 x 94 x 272
Remote control unit:
482 x 132 x 83
Weight
Main unit:
5.7kg
Remote control unit:
2.5kg
The following values are applicable when key and
tempo values are set to 0.
Frequency response:
20 – 20kHz, +0.5/-1.0dB
Dynamic range:
>95dB
S/N ratio:
>95dB
Total harmonic distortion:
<0.01%
Error Messages
Err 01
TOC Read error - the disc's Table of Contents cannot be read within 20 seconds - try with another
disc or remove and clean the existing disc before replacing it
Err 02
GFS error – GFS signal cannot be detected within five seconds - try with another disc or remove
and clean the existing disc before replacing it
Err 03
Focus error - after repeating the attempt eight times to focus, an error still occurs - try with another
disc or remove and clean the existing disc before replacing it
Err 04
Sub-Q error - the sub-Q code cannot be detected (twice within five seconds) - try with another
disc
Err 05
Loading error - the open or close operation cannot be completed, even after retries, or there is an
internal error - make sure that there are no obstructions preventing the tray's operation
Err 06
Sled error - an internal drive error - try turning the power off, waiting a few seconds, and turning
it on again
Err 07
Error in communication between decks - try turning the unit off, waiting a few seconds, and
turning it on again
Err 10
S-DRAM error - an internal S-DRAM error - try turning the power off, waiting a few seconds,
and turning it on again
If any of the numbered error messages occur, try using another disc.
If the errors continue with a number of discs, turn the unit off, wait for a few seconds, and turn it on again.
If the errors still continue or other error occurs, contact your TASCAM distributor for repair.
