5
PUNCH IN/OUT
(Auto)
1)
Use the Memo Point Capture function, treating LOC 1 as the Punch In point and
LOC 2 as the Punch Out point
2) Place the DA-60
MK
II in EDIT AUDIO MODE
3) Press AUTO IN/OUT, its LED will light solid
Rehearsal:
4) Press REHEARSAL - tape will locate to the preroll position prior to the punch in
point and stop (the AUTO IN/OUT LED will blink)
5) Press PLAY - at the IN point the DA-60
MK
II will flip from Tape to Source Monitor, and
then back to Tape Monitor at the OUT point, tape will rewind and stop after 3 second
postroll
Take:
6) With AUTO IN/OUT blinking, press RECORD - RECORD key will blink
7) Press PLAY, the procedure will be executed
PUNCH IN/OUT
(Manual)
1)
Place the DA-60
MK
II in EDIT AUDIO MODE
2) Press MONITOR until "TAPE" shows in the display
3) Press PLAY, at IN Point tap RECORD (DA-60
MK
II will monitor "SOURCE")
4) At OUT Point tap PLAY (DA-60
MK
II will monitor "TAPE")
5) Press STOP
PULL DOWN
1)
Set CLOCK to VIDEO
2) Hold SHIFT and press MENU
▲
or
▼
until you arrive at screen display "14 bAnd",
press DATA (current status will blink)
3) Rotate the DATA DIAL to "nrr oFF" and press SET
4) Make certain the Time Code format is "30ndf / 30df"
5) Video In signal = 29.97 Hz
PULL UP
1)
Set CLOCK to: [INT without a 30 Hz video signal] or to [VIDEO with a 30 Hz video
signal]
2) Hold SHIFT and press MENU
▲
or
▼
until you arrive at screen display "14 bAnd",
press DATA (current status will blink)
3) Setting: [Without a 30 Hz video signal - N/A], or [With a 30 Hz video signal - "nrr
oFF"] - press SET to confirm
4) Make certain the Time Code format is "29.97ndf / 29.97df" with or without a 30 Hz
video signal
5) The VIDEO IN signal = 30 Hz
6) Pitch Change: [Without a 30 Hz video signal: +0.1% VARISPEED], N/A with a 30 Hz
video signal
Note: N/A represents non-applicable
