DM-3200 Release Notes
1
TASCAM DM-3200 Release Notes V1.50
GPI functionality
DM-3200 Ver1.20 supports GPI functionality. This allows
you to send 8 output signals from the
GPI
port (D sub
9-pin connector) on the rear panel, and control external
devices from the DM-3200.
The DM-3200 allows you to give different trigger settings
to each of the
GPI
ports for GPI signal output. You can
choose the trigger source from a
FADER
,
MUTE
key
control, transport control, machine control key status and
its operation, or a timecode value.
Making connections
The arrangement of the serial port pins of the
GPI
ports on
the rear panel is as follows:
Pin number
Function
#1
GPI output port
#2
GPI output port 2
#3
GPI output port 3
#4
GPI output port 4
#5
GND
#6
GPI output port 5
#7
GPI output port 6
#8
GPI output port 7
#9
GPI output port 8
Output level: 5V
Settings that can be interlocked
The following settings are interlocked between the two
DM-3200 units while there is a cascade connection
between them. The initial settings on the cascade master
will be reflected on the cascade slave immediately after a
cascade connection is established.
Layer status
Flip mode
Encoder mode
Surround mode
Surround 5.1 rear MONO
DIGITAL>CASCADE
screen setup (except for
ID
setting)
OPTION>SETUP
screen setup (except for
FADER
SENSITIVITY
)
OPTION>PREFERENCE
screen setup
OPTION>SOLO
screen setup (except for
INPLACE SOLO
DEFEAT
setup)
OPTION>ENCODER MODE
screen setup
METER/FADER>METER
screen setup
SNAPSHOT RECALL SAFE
setup on the
LIBRARY SNAPSHOT
screen
AUTO SETUP
screen setupºKey setup in the
AUTOMATION
section (
WRITE
,
TRIM
,
ALL SAFE
,
REHEARSE
,
INITIAL EDIT
)
After the cascade connection has been made, whenever
a setting is changed either on the cascade master or the
cascade slave, the changed setting will be reflected on the
setting of the other unit. However, the ON/OFF setting of
the cascade connection can only be changed on the cascade
master.
ª
•
•
•
•
•
•
•
•
•
•
•
•
•
Operations that can be interlocked
The following operations are interlocked while there is
an established cascade connection between two DM-3200
units. Whenever any of the below operations is executed
either on the cascade master or the cascade slave, the other
will follow with the exact same operation.
Snapshot related operations:
Recall
Store
Delete
Automation key operations:
TOUCH
key
KEEP
key
REVERT
key
INITIAL EDIT DISCARD
key
AUTO FADE
key
ª
Settings and Operations that can be interlocked
