DM-3200 Release Notes
TASCAM DM-3200 Release Notes V1.50
Module parameter copy function
You can now copy module parameters from a module to
another module.
PARAM COPY settings
Access the
UTILITY>PARAM.COPY
screen. The copy opera-
tion is performed in the
MODULE TO MODULE
section of
this screen.
Figure 10 UTILITY>PARAM.COPY screen
1. The upper part of the
MODULE PARAMETERS
section
lets you copy from one module to one other module,
and the lower part lets you copy from one module
to multiple modules. Use the radio buttons to select
the desired type of copy operation.
2. Use the cursor keys to move the cursor, use the
JOG/DATA
dial to select the module that you
want to copy (left side), and press the
ENTER
key.
Select the copy-destination module (right side) in
the same way.
3. Move the cursor to the
COPY
button and press the
ENTER
key.
A popup message will ask you for confirmation.
4. Press the
ENTER
key to execute the copy.
If you decide to cancel, press any cursor key.
PASTE SAFE
In the
PASTE SAFE
section you can select the parameters
that will be pasted.
Parameters whose square check boxes are selected will not
be pasted.
You can copy/paste from a CHANNEL to a master module
such as a BUSS or AUX, or the reverse. In this case,
parameters existing at the copy-source but not the copy-
destination will not be copied; they will retain their state
from before the paste operation. The same applies to
parameters that don't exist in the copy-source but do exist
at the copy-destination.
ª
The
–
symbols at the right indicate parameters that exist in
the corresponding modules.
NOTE
Module functions include some parameters not shown
in this list, such as DIGITAL TRIM, but parameters not
shown in the list will not be copied/pasted.
BUSS pan mode batch setup
In the
ASSIGN>BUSS
screen,
BUSS PAN MODE BATCH SETUP
has been added to allow one-step setup of BUSS pan mode.
Figure 11 ASSIGN>BUSS screen
1. Move the cursor, use
MODULE
to select the channel,
use TARGET to select the busses whose pan mode
you want to change, and use
ON/OFF
to specify the
on/off setting.
2. Move the cursor to the
SET
button and press the
ENTER
key.
A popup message will ask you for confirmation.
3. Press the
ENTER
key to execute the copy.
If you decide to cancel, press any cursor key.
ª
Operation
