7–Recorder Functions
TASCAM DP-004
71
the way left (bounced to track 1 or 3) or all the way
right (track 2 or 4). Use the
MASTER LEVEL
knob to
adjust the overall level.
6 After returning to the start of the song, press the
playback (
Á
) key while pressing and holding the
record (
–
) key to start the bounce.
Confirming the result
Raise the bounce destination track
LEVEL
knob (turn
other track
LEVEL
knobs all the way down) and
the
MASTER LEVEL
knob, and start playback from
the beginning of the song. If you are not satisfied
with the result because, for example, the balance
between instruments is poor, or the pan settings are
wrong, use the undo function (see “Undoing the last
operation (single undo)” on page 66).
If you are satisfied with the result, press the
REC
MODE
key to open the
RECORDER MODE
screen and
select
MULTI TRACK
, then press the
HOME
key to return
to the Home Screen.
After bouncing tracks, you can make new recordings
over the other tracks.
TIP
If it is possible that you might need the original tracks at
some later time, back-up the track data to a computer or
copy the song before bouncing (see “Backing-up songs”
on page 94 and “Connecting with a computer” on page
Locate and search functions
Direct locate function
This is the way to locate a specific position in a
song. The current recorder position is shown at
the top of the display as “hours: minutes: seconds:
frames” (there are 30 frames per second). You can
move the transport location to a specific time by
inputting it here.
1 Use the
F1 (
DIGIT
)
key to move the cursor (underline)
between the time divisions. You can edit the value
at the cursor positions. The seconds are selected in
the following figure.
