11–Exchanging Data with a Computer
TASCAM DP-004
93
before the USB connection becomes effective.
When connected, the following screen appears on
the display.
If you turn the unit’s power ON after making the
USB connection, the screen above appears right
away.
The unit appears as an external drive named
“DP-004” on the computer’s display.
CAUTION
Do not make a USB connection when the remain-
•
ing battery level is low.
If the power turns OFF during data transfer, all the
•
data will be lost. This lost data cannot be restored.
NOTE
Confirm that you have copied all the files that you want
to transfer to a computer to the FAT partition before
connecting the unit and the computer by USB.
Disconnecting
Use the following procedures to disconnect the USB
connection correctly.
NOTE
When disconnecting from a computer, the procedure on
the computer might be called “eject” or “unmount.”
CAUTION
When transferring data, do not disconnect the unit or
remove the USB cable. Doing so could cause data on
the computer or this unit to be damaged.
Disconnecting from Windows 2000 (SP4 or later)/
Windows XP/Windows Vista systems
Follow the procedures below to disconnect
computers that use Windows 2000 (SP4 or later),
Windows XP or Windows Vista operating systems.
A PC card icon and arrow appear in the taskbar
(usually at the bottom right of the screen).