46
TASCAM DR-44WL
9 – Mixer
The mixer functions that can be used for setting a built-in effect,
right and left positions and volume balance for each channel are
available.
Recording sound can be finely changed by setting these during
mixing down or playback. (See “Mixing down” on page 45.)
Setting the mixer
1. When the Home screen is open, press MIXER to open the
Mixer screen.
in 4CH mode
Stereo Link is set
MS decoder is used
2. Use the wheel to select (highlight) an item you want to
change).
3. Press ENTER/MARK button to pop up setting items and
settings on the left.
4. Use the wheel to change the setting.
Items
Options
Action
SEND
0 - 100
Adjusts the forwarding level
of the selected reverb (See
48.).
(0: Minimum to 100:
Maximum)
PAN
L12 - C - R12
Adjusts the balance between
the right and left channels.
(L12: Left - C: Center - R12:
Right)
LEVEL:
0 - 100
Adjusts the volume balance
between the right and left
channels. (0: Minimum to 100:
Maximum)
RTN
0 - 100
Adjust the total volume of the
signals with reverb applied
sent from the SEND buses of
each channel (track).
5. Press the ENTER/MARK button to return to the original
position where you can select the position to change the
setting next time.
NOTE
•
Operation is available in any mode when playing back,
stopped, paused, or in recording standby or recording.
•
While the Mixer screen is open, press the
7
/
9
button to
play back or press
8
/HOME
button to pause the playback.
