TASCAM HS-2000
107
11 – Internal settings
function, which allows you to enter playback standby
from playback by lowering the fader to –∞.
Setting buttons: Disable, Enable (default)
NOTE
If both FADER Start MODE and FADER Stop MODE are set
to Disable, the fader start function of the external TASCAM
HS32PD/RC-HS20PD remote controller (sold separately)
will be turned off automatically, and the FADER START
indicator will turn off. In this state, if you press the Fader
Start key on the TASCAM RC-HS32PD remote controller,
a “Cannot Change Now. Fixed in current mode” pop-up
warning appears.
PARALLEL page
Set the AUX 1-3 functions of the PARALLEL connector.
AUX Assign
Touch a knob to select it, making the parameter
background yellow, and turn the DATA dial to select
the parameter. The parameters that can be selected
include F.FWD, REW, MARK, MARK SKIP–, MARK SKIP+,
ONLINE and CALL.
AUX1 Function (default:
•
MARK SKIP+):
Set the function of PARALLEL connector pin 17
(AUX1).
AUX2 Function (default:
•
MARK SKIP–):
Set the function of PARALLEL connector pin 18
(AUX2).
AUX3 Function (default:
•
MARK):
Set the function of PARALLEL connector pin 19
(AUX3).
BWF-J Tally
When not operating in BWF–J mode (when Follow
BWF-J is OFF), set whether a BWF–J tally is output.
Setting buttons: OFF (default), ON
NOTE
BWF-J tallies are always output when operating in BWF-J
mode.
RS-232C page
Make RS-232C serial control transmission settings on this
page.
Serial Mode
Set the serial connection mode with the following
buttons.
Setting buttons: RS-232C, RS-422 (default)
NOTE
The
•
RS-232C and RS-422 connectors cannot both be
used at the same time. Only the connector selected
with this setting can be used.
This setting is synchronized with the Serial Mode item
•
on the RS-422 page.
Baud Rate (bps)
Set the transmission speed (baud rate) with these
buttons.
Setting buttons (bps): 4800, 9600, 19200, 38400
(default)
Data Length
Set the data length in bits with these buttons.
Setting buttons (bits): 7, 8(default)
Parity Bit
Set whether there is a parity bit and the type with
these buttons.
Setting buttons: NONE (default), EVEN, ODD
Stop Bit
Set the stop bit with these buttons.
Setting (bit): 1 (default) or 2
