8
TASCAM HS-2000
1 – Introduction
Intellectual property rights
TASCAM is a trademark of TEAC Corporation, registered
•
in the U.S. and other countries.
CompactFlash is a US registered trademark of SanDisk
•
Corporation.
Other company names, product names and logos in
•
this document are trademarks or registered trademarks
of their respective owners.
Any DATA, including, but not limited to information,
described herein are intended only as illustrations
of such DATA and/or information and not as the
specifications for such DATA and/or information.
TEAC Corporation disclaims any warranty that any use
of such DATA and/or information shall be free from
infringement of any third party’s intellectual property
rights or other proprietary rights, and further, assumes
no liability of whatsoever nature in the event of any
such infringement, or arising from or connected with
or related to the use of such DATA and/or information.
This product is designed to help you record and
reproduce sound works to which you own the
copyright, or where you have obtained permission
from the copyright holder or the rightful licensor.
Unless you own the copyright, or have obtained the
appropriate permission from the copyright holder
or the rightful licensor, your unauthorized recording,
reproduction or distribution thereof may result in
severe criminal penalties under copyright laws and
international copyright treaties. If you are uncertain
about your rights, contact your legal advisor. Under no
circumstances will TEAC Corporation be responsible
for the consequences of any illegal copying performed
using the recorder.
Precautions for placement and
use
The guaranteed operating temperature range of this
•
product is 5º - 35º C (41º- 95º F).
Do not install in the following types of places. Doing
•
so could degrade the sound quality and/or cause
malfunctions.
Places with significant vibrations or that are
•
otherwise unstable
Near windows or other places exposed to direct
•
sunlight
Near heaters or other extremely hot places
•
Extremely cold places
•
Places with bad ventilation or high humidity
•
Dusty places
•
Make sure that the unit is mounted in a level position
•
for correct operation.
In order to promote the emission of heat, do not place
•
anything on top of this product.
Do not place this product on top of a powered
•
amplifier or other equipment that emits heat.
Beware of condensation
If the unit is moved from a cold to a warm place, or
used immediately after a cold room has been heated or
otherwise exposed to a sudden temperature change,
condensation could occur. Should this happen, leave the
unit for one or two hours before turning the unit on.
Cleaning the unit
Wipe the unit with a soft dry cloth to clean it. Do not use
paint thinner, alcohol or other chemical agents. Doing so
could damage the surface of the unit or cause fading.
Cleaning the display
Slightly wipe the display with a soft dry cloth that does
not shed dust (e.g. a cleaning cloth). Avoid wiping with a
stiff cloth or rubbing with force. Doing so could damage
the surface of the LCD. Do not use thinner, manicure
remover, alcohol or similar substances.
