TASCAM HS-2000
91
9 – Playlist mode
Editing the playback starting and
ending points using the number
buttons and mark list screen
1. When you touch the
EDIT
button on the Start End
Point page of the
ADJUST XXX
screen, the
EDIT
START POINT
or
EDIT END POINT
screen for
editing the playback start or end point is shown.
Use the
FRAME EDIT
button on the
EDIT START
POINT
screen to set whether or not you will edit the
frame value.
2. Use the number buttons to input the playback start/
end point.
If you begin input without selecting a unit, input will
•
start from the smallest one.
To input a specific unit, touch it to make its
•
background yellow, and then use the number
buttons and the DATA dial to enter two digits at a
time.
Touch the
•
CURRENT
b
button to copy the current
playback position to the input value.
Touch the
•
SET MAX
5
button to set the end time
of the file as the value.
Touch the
•
CLEAR
button to reset all values to 00.
Touch the
•
Mark List
button to open the mark list
where you can copy the time from a specific mark.
On this screen, touch the
w
button of next to a mark
to copy its time to the playback start/end point and
return to the
ADJUST XXX
screen.
3 Touch the
ENTER
button to confirm the setting.
NOTE
When you change the playback start/end time, the length
of the interval between the playback start and end times
will be adjusted automatically so that it is longer than the
total length of the fade-in and fade-out.
TIP
You can also use the
•
PLAY key and other transport
keys while listening to the audio to find a location, and
then touch the
CURRENT
b
button to input that
value.
This can also be edited using an external keyboard
•
on the
EDIT START POINT
and
EDIT END
POINT
screens. Press the keyboard’s ESC key to clear
all values (set them to 00).
