10
TASCAM IF-DA2
2
Receiving device channels
These are the names of the channels of the receiving device
on the Dante network.
3
Transmitting device name
This is the name of a transmitting device on the Dante
network.
4
Transmitting device channels
These are the names of the channels of the transmitting
device on the Dante network.
5
Audio routing
Route the audio channels of the transmitting and receiving
devices that you want to connect here.
Left-click the intersection of the channels you want to
connect on the matrix to connect them.
NOTE
While pressing the computer keyboard Ctrl key, left-click
the “-” at the intersection of device names to connect all
connectable channels at once.
Changing sampling frequencies and bit
depths with Dante Controller
Double-click a device name on the Network View screen to open
the Device View screen.
On this screen, you can set and monitor conditions related to
devices on the Dante network.
Click the Device Config tab to open the page where you can
change the sampling frequency, bit rate and other settings of the
device selected in
1
shown in the illustration below.
Summary of Contents for IF-DA2
Page 42: ...42 TASCAM IF DA2 Gebrauchsanleitung...
Page 52: ...52 TASCAM IF DA2...
