Section VI, Continued
Section VI, page 6
To assign the internal effects to either the EFFECT RETURN -or- AUX RETURN:
1) Press SHIFT and PARAM SEL simultaneously.
Option
Setup
?
2) Rotate the DATA ENTRY dial to Setup.
.
Press ENTER.
Setup
Eff Rtn Input/Assign
?
3) Rotate the DATA ENTRY dial to Eff Rtn
Input/Assign or Aux Rtn Input/Assign.
.
Press ENTER.
Eff Rtn Input/Assign
Input:Effect2
Eff Rtn Input/Assign
Assign L-R: On
4) Rotate the DATA ENTRY dial to the desired input
source.
Press ENTER.
5) Push the DATA ENTRY dial down to assign the
EFFECT RETURN or AUX RETURN to the L/R output
or buss 3-4 (if available). Press ENTER.
.
---------- Which Effect is it?!?!? ----------
With all the effect combination possibilities, it can get confusing which effect is on Aux 1-2, or Master
L/R, or whatever. While it is easy to see in the chart we provided in this manual where it details all of the
effect possibilities, what happens if you don’t carry this manual with you everywhere you go?
It is
possible to simply ask the mixer what effect processors are assigned where. To get to this screen:
Press SHIFT and OPTION MONITOR simultaneously. (OPTION MONITOR is located just under the
ENTER key.
Press the DATA ENTRY dial down until the bottom line reads Effect.
Rotate the DATA ENTRY dial all the way to the right, and the screen will display your effects set-up.
NOTE: These effect set-up examples are only possible with the optional FX-D1000 expansion card.
This screen indicates that there are 4 channel dynamics, and Stereo Effect
2 is assigned to Aux 1-2, and Stereo Effect 5 is assigned to Aux 3-4.
Eff Comb
Ch Dynamics
?
: 3-4
E2
E5
1-2
Eff Comb1-2
E2-E5
?
: 3 :
4
E1m E4m
This screen indicates that Stereo Effect 2 is cascaded into Stereo Effect 5
on Aux 1-2, Effect 1 is fed in mono on Aux 3, and Effect 4 is fed in mono
on Aux 4.
TASCAM TM-D1000 Tutorial
1/99
TASCAM
TM-D1000
