4 - Module operations—MODULE screen (miscellaneous)
4–11
4.11.1Global delay setting
Use POD 1 of the last row to set the value and copy it
to all busses (right switch of POD 1) for the “global”
buss delay:
Confirm the setting with the
ENTER
key or cancel
with a cursor key.
4.12MODULE screen
(miscellaneous)
In the
MODULE
screen, a meter is shown to the
right of the screen:
4.12.1Meter pickoff point
Immediately below the meter is a description show-
ing the “pickoff” point for the meter (
POST-EQ
in the illustration above).
Move the cursor to this description and press the
ENTER
key to cycle through the following pickoff
points:
POST-EQ
(after the equalization),
POST-DYN
(following the dynamics processor)
or
POST-FADER
(after the channel fader).
This also applies to the
STEREO OUT
. In this case,
only the on-screen meters are affected. If this buss is
selected for monitoring using the hardware meters,
the meter readings will not be changed by this
operation.
4.12.2Other information
The
MODULE
screen also shows the current fader
and cut group assignment for the module (see 4.9,
“Fader and cut groups”), the group assignments (and
direct output assignment if appropriate).
A representation of the current fader position is also
given, together with the fader level, relative to the
nominal level. The cut status is also shown, immedi-
ately above the fader representation.
4.13Soloing
Modules may be soloed by pressing the
SOLO
key of
a module.
The exact action taken depends on the solo mode
currently selected, as well as the Inplace Defeat set-
ting for the module and other modules.
See 5.4, “SOLO” for details of solo settings and
operations.
