TASER CAM HD Recorder
MMU0036 Rev: A
Page 6 of 48
Replacement.
The rechargeable battery in the TASER CAM HD
system may be replaced by a qualified technician. Do not use any
battery other than those designated by TASER. Doing so may cause
battery explosion, battery leakage, system damage, injury, or fire.
Handling.
Do not carry or store the TASER CAM HD recorder in places
where the battery contacts may become dirty or short-circuited. To
avoid risk of fire, burns, or damage to your battery pack, do not allow a
metal object to touch the battery contacts. Do not strike or throw the
battery against hard surfaces. Do not directly solder the battery or
pierce the battery with a nail or other sharp object. Never disassemble,
short circuit, or heat batteries or put batteries in a fire. Doing so may
cause battery explosion, battery leakage, system damage, injury, or fire.
Abnormal Appearance.
If the battery gives off an odor, generates
heat, becomes discolored or deformed, or in any way appears abnormal
during use, recharging, or storage, immediately remove it from the
device or battery charger and place it in a contained vessel such as a
metal box.
Disposal.
Dispose of the battery properly; contact your local waste
disposal provider regarding local restrictions on the disposal or
recycling of batteries. Do not dispose of the battery in fire or heat. The
battery may explode if placed in the fire.
Safety Information: General Maintenance & Use
Failure to use or maintain the TASER CAM HD system as instructed
may cause the ECD or system to malfunction or fail to function properly
or optimally. Follow and comply with the following instructions to
reduce the risk of malfunction, including failure or loss of data:
Charging the TASER CAM HD recorder.
Do not insert the TASER
CAM HD recorder into an X2 ECD until the recorder is fully charged.
Recharge the TASER CAM HD recorder frequently, before the remaining
battery capacity is less than 50 percent. If the battery is not properly
charged the ECD and/or the TASER CAM HD may not work or may fail to
function as expected. To charge the recorder, only use the approved
TASER charging cables. Do not recharge the TASER CAM HD recorder
out of the recommended temperature range of 32 °F to 104 °F (0 °C to
40 °C). Charging out of this recommended range may cause damage to
