32
Cleaning the sponge and pump protection filter
Washing out the squeegee
Replacing the brush roller
Cleaning the brush housing
Installing the brush housing
• Remove the light-blue sponge filter using
pincers.
Wash the sponge filter every month.
Replace the sponge filter when necessary.
• The pump protection filter should be replaced
once a year.
• Open the cover of the brush housing by
loosening the unlocking device at the side.
• Turn the four yellow clips to the left to loosen the
squeegee.
• Place the machine on its side to remove the
squeegee.
• Wash out the squeegee under running water.
Check the condition of the suction lips before the installation.
Bristles that vare too short or damaged suction lips could impair
the cleaning result!
1
2
• Replace the squeegee in the squeegge body.
Note that the front and rear squeegees are
different. The position is shown on the upper
side of the squeegee (FRONT + REAR).
Caution:
Danger of injury through sharp objects.
Wear gloves for your own protection!
Check the brush roller for wear after every use.
Bristles that are too short or damaged suction lips could lead to
damage to the floor covering and could impair the cleaning result!
• Place the machine on its side so that the side
brush holder is facing upwards.
• Press the rotation lock (1) and turn the brush
holder (2) counter-clockwise and pull it out of
the housing (3) to remove it.
• Remove the brush roller.
• Clean the brush roller.
• Clean the brush housing with a damp cloth.
• Reinstall the brush roller.
In order to reinstall the brush roller, you have to
position the white traveller of the roller on the
white traveller in the squeegee body.
The ribs on the traveller of the brush roller must
fit into the correct cutouts on the traveller of the
squeegee body.
• Remount the brush holder and turn it clockwise
until the rotation lock locks in.
2
1
3
2
1
