48
Prior to commissioning
Insert a pad
Before inserting, please check:
• the pad for wear and cleanliness.
Application technique
Dosing:
Attention:
Do not use worn or dirty pads. Use original
TASKI brushes only. Failure to observe
these instructions may result in inade
-
quate cleaning results or even floor dam
-
age.
• Stand behind the machine.
• Pull the adjusting lever at the ma
-
chine handle and tilt the steel guide
bar upwards until it is completely up
-
right.
• Release the adjusting lever to lock
the steel guide bar.
Notice:
Remove the product container before tilt
-
ing the machine backwards.
• Tilt the machine backwards until the
machine handle is lying on the floor.
• Unscrew the fixation disc from the
pad holder.
• Place the pad centrally on the driving
disc and screw the fixation disc on
again.
Always tighten the fixation screw
very firmly, as otherwise the floor
may be damaged by the protruding
fixation screw.
• Put the machine slowly in a vertical
position again.
Machine
ergodisc 1200
Wet & base cleaning
no
Spray cleaning
no
Shampoo wet
no
Shampoo dry
no
Polish
yes
Spray polishing
yes
Grinding
no
Crystallization
no
Attention:
Wear gloves, goggles and appropriate
(protective) working clothes when han
-
dling chemical products!
Notice:
Use chemical products recommended by
Diversey only and always observe the
product information.
Caution:
Using unsuitable products (e.g. products
containing chlorine, acids or solvents) may
cause harm to health and severe damage
to the machine.
Notice:
The correct dose is specified on the prod
-
uct packaging and in the "TASKI Product
information sheet".
