GTS
Technical Manual
19. April 2010
Edition: V1.00/2010
5-27
Copyright © 2010, Diversey Inc.
05.0 s
w
in
go 1255 B Power - me
ch
anics
.fm
5.1.6.3 Replacing of electrical brush unit (EBU)
Picture 29: Electrical brush unit
Remove
•
Lay machine on the LH side.
•
Remove special screw (06/136) to release tie rod.
•
Disconnect the linear drive wiring.
•
Pull out stop pin (06/108).
•
Remove bolt (06/107) for the linear drive fixation.
Remarks
To pull out the bolt, you need to thread in a screw into the bolt.
Dimensions: M6, length > 30mm.
•
Thread out the complete linear drive.
Mount
•
Thread in the complete linear drive.
Adjustment
The distance between the linear drive fixation bracket and the outer
end of the tie rod has to be as bellow.
Picture 30: Linear drive fixation distance
•
Mount bolt for linear drive fixation and secure with stop pin.
•
Connect linear drive wiring.
•
Mount special screw to fix the tie rod.
•
Lift up machine again.
Summary of Contents for swingo 1255B Power
