28
Washing out the filter housing and the float
Cleaning the sponge and pump protection filter
Washing out the squeegee
Replacing the brush rollers
Cleaning the brush housing
• Remove the motor protection filter from the filter protection before you wash
out the filter housing.
• Wash out the filter housing and the float (X),
which is located on the underside of the filter
housing, under running water.
• Reinstall the dry motor protection filter.
• Place the filter housing on the tank and latch it
into place (see page 26).
• Remove the light-blue sponge filter using a pair
of pliers.
Wash out the sponge filter monthly.
Replace the sponge filter if necessary.
• The pump protection filter should be replaced
once a year.
• Open the cover of the brush housing by
releasing the unlocking device at the side.
• Turn the four yellow clips to the left to release
the squeegees.
• Bring the machine onto its side to remove the
squeegees.
x
2
1
1
2
• Wash out the squeegees under running water.
Check the condition of the suction lips before installing.
Bristles that are too short or damaged suction lips could impair the
cleaning result!
• Replace the squeegees in the squeegee body.
In doing this, note that the front and rear
squeegees are different. The position is given
on the front side of the squeegee (FRONT +
REAR).
Caution:
Danger of injury by sharp objects.
Wear gloves for you own protection!
After every use, check the brush roller for wear.
Bristles that are too short or a damaged brush roller could
damage the floor surface and impair the cleaning result!
• Lay the machine on its side so that the side
brush holder points upwards.
• Press the rotation lock (1) and turn the brush
holder (2) counterclockwise and pull it out of the
housing (3) in order to remove it.
• Remove the brush roller.
• Clean the brush roller.
• Clean the brush housing using a damp cloth.
2
1
3
