swingo 1650/1850 Wet Cell Conversion
Log in to USA
fi
x
™
at www.usaclean.com
1-800-USA-CLEAN (800-872-2532)
9. Add the switch lever to the
end of the new switch harness.
This switch is the kill switch
that prevents the machine from
turning on while it is charging.
10. Using a small Phillips
screwdriver, attach the new plug
to the back panel
11. Using zip ties, group
the wires together and then
reattach back panel
12. Lift up the tank and pull
the wires through from the
back panel into the battery
compartment.
13. Connect the red cable from
the charger plug to the solenoid
with a 13mm wrench.
19. Using a T30 torx, remove
bracket on tank lid from top set
of holes. The bracket can be
discarded but keep the screws.
14. Feed the black cable from
the charger plug to connect to
the battery cable.
20. Attach prop kit lock
assembly to the bottom set of
holes on tank lid with screws
from the bracket removed in
step 19.
15. Insert the battery tray
22. Plug in USB cable and
update
fi
rmware with laptop to
wet battery con
fi
guration.
16. Install wet batteries.
17. Please note that the battery
cables have a positive and
negative icon on the speci
fi
ed
sides.
18. Hook up the battery
cables and tighten terminals
with 10mm wrench. The main
terminal uses a 13mm wrench.
For service tool and
fi
rmware updates please login to www.usaclean.com and go to the documents drop down menu to download materials.
21. Using a 13mm wrench,
install prop to frame so the prop
is at a 90 degree angle to the
frame.
Note: If the lid does not close all
the way, the lock assembly may
need to be adjusted.
