81
Charging procedure with external charger
Charging procedure with (optional) on-board charger
After charging
Maintenance and care of open (wet-cell) batteries
Open battery compartment for maintenance
Variant: Machine with wet battery set
After maintenance, carefully tilt the tank back to its initial posi
-
tion and lock it.
Attention:
Before decommissioning the machine for
a longer period, the batteries must under
-
go a complete charging cycle. After com
-
pletion, the charger is disconnected from
the machine and/or mains. Batteries grad
-
ually discharge. Depending on the type of
battery, they must be recharged after 3-6
months. Before recommissioning, the bat
-
teries should undergo another complete
charging cycle.
• Connect the external battery charger with the battery iso
-
lating plug of the machine.
Attention:
Make sure that the plug is inserted up to
the stop in order to ensure a good electri
-
cal contact.
Notice:
All machine functions are deactivated
during charging.
• The machine must be switched off.
• Take the power cord and connect it with a socket (with slow
fuse).
Attention:
Switch off the charger before disconnect
-
ing the batteries (only for external char
-
gers).
Disconnecting the charger while it is still
switched on may result in an explosion in
the battery compartment.
• Stow away the power cord for (optional) on-board chargers
in the provided compartment.
• Store the charging cable in a dry place where it is protected
against damage.
Attention:
Charging cables transfer high currents. Do
not use the charger if there are any signs
of damage to the plug, cable or device
connection.
Notice:
The care for maintenance-free batteries is
limited to the compliance with the correct
charging processes and correct adjust
-
ment of the charging curve.
• The machine must be switched off.
Caution:
Before opening the battery compartment
make sure that both tank areas are empty.
• Disconnect the battery from the machine at the battery dis
-
connection socket.
• Lower the squeegee.
• At the bottom left and right on the
front side of the machine you will find
the battery compartment release.
• Unscrew both screws and remove
them.
• At the bottom left on the front side of
the machine you will find the battery
compartment release.
• Press the release (e.g. with a screw
-
driver) into the intended opening and
lift the tank until it locks.
• Tank position before change of posi
-
tion.
• Stand behind the machine.
• Carefully open the battery compart
-
ment until the driving handle is on the
ground.
• Carefully open the battery compart
-
ment until the driving handle is on the
ground.
Notice:
Lift the suction nozzle again
Notice:
Connect the battery with the machine at
the battery disconnection socket.
EN
