www.tasking.com
mDIO Cable
Ordering code
BB-AP-MDIO-20
mDIO Cable is used to connect the Active Probe mDIO port with the signals around the debugged
microcontroller, which can then be either read or controlled by the debugger. For example, the de-
bugger can periodically service an external watchdog through the mDIO output or just read and re-
cord an external signal through the mDIO input. It must be ordered separately. Length of the cable
is 20 cm.
The following pinout is valid on the Active Probe side:
Number
Name
Color
Pin1
IOØ
White
Pin2
IO1
Brown
Pin3
GND
Black
mDIO Cable pinout
