For general dusting wipe the cot with dry soft cloth
To remove spills, dirt or anything your baby throws at you use warm soapy water
Avoid using a scourer/steel wool, these damage the finish
Always dry the cot after cleaning
This cot is manufactured to use with a mattress sized 750mm (W) x 1310mm (L) x 120mm (H).
It is important that the gaps between the mattress, sides and end of the cot do not exceed 40mm
when the mattress is pushed to one side and it should not exceed 20mm when the mattress is
centred in the cot. This minimises the risk of a child's limb becoming caught in a gap.
Mattress thickness specified ensures the depth of the cot is greater than 500mm with the
mattress base in the lower position, minimising the risk of a child climbing and falling from the
cot.
Follow manufacturer's assembly instructions in detail, ensuring safety features are not
compromised.
ENSURE THE COT IS NOT POSITIONED TOO CLOSE TO HEATERS, BLINDS, CURTAINS,
WINDOWS OR POWERPOINTS.
DO NOT KEEP ITEMS NEARBY WHERE THERE IS DANGER OF THE ITEM FALLING INTO THE
COT.
KEEP ANY MEDICATION, STRING, ELASTICS OR SMALL ITEMS OUT OF REACH OF YOUR COT,
PREVENTING THE CHILD REACHING FROM OUT OF THE COT, WITH ANY SUFFOCATION OR
STRANGLE RISKS.
TO PREVENT FALLS, THE BASE OF THE COT SHOULD BE ADJUSTED TOTHE LOWEST POSITION
BEFORE YOUR CHILD CAN SIT UP.
Tighten your connector bolts, at least two months after cot assembly, some may loosen as the
cot settles.
Regularly check your connector bolts, ensuring they are tight, and regularly check the cot for any
weakness in the panel joints and panels. If weaknesses are found, report immediately, to Tasman
Eco (services@tasmaneco.com.au).
Do not use the cot if it has been damaged in any way.
Always use spare parts direct from Tasman Eco, these can be purchased via the website.
Cleaning and Care
Recommended Mattress Size
Safety Considerations - Cot
Safety Considerations - Child
