9
Step 3 - Attach base frames
Unfurl the lattice base frames.
Note: Do not cut the fabric webbing that
holds the slats together.
Fit the lattice base frames between the
bed rails.
To secure the frames, stretch the
first and last slat of the over the
corresponding dowel pins.
Repeat this step for all remaining sides.
Stretch the first and last slat of the
base frame over the dowel pins.
Do not cut the
fabric webbing
Step 4 - Insert cap screws
Hardware needed
IMPORTANT SAFETY STEP
Fit the small cap screws to the 4
remaining unused locating holes
(2 on each bed head). This is a
required safety step to prevent
the entry of small fingers into
these holes.
x4
4 x 15mm cap screws
Summary of Contents for Verona Cot
Page 11: ...11 ...
