VERTICAL TOWED MIXER - TWO AUGERS
MV-30D SERIES
LUBRICATION
COMPONENT
Unloading conveyor
Bearings
Drive Shaft
Power take off
Wheel bearings
Universal joints
CV joints
Hydrostatic system
Oil filters
CHART
INTERVALS
Brush or spray lightly
every 40 hours of
operation.
Every 8 hours
Every 8 hours
At each lubrication, make
sure the PTO shaft enters
and exits freely, any slip
fault can cause damage to
the drive shaft.
Every 12 months
Every 8 hours
Every 8 hours
Only when the system has
been contaminated
TYPE OF LUBRICANT
Light oil
Good quality grease
Good quality grease
Lithium based grease
Good quality grease
Good quality grease
Hydraulic fluid:
T-04SAE10W
24 hours after system startup.
Regular maintenance every 500 hours.
AT THE END OF THE WORK.
At the end of the operation:
- adjust the brakes,
- disconnect all power units,
- turn off the engine and
- remove the ignition keys.
Always, store the unit in a place away from human activity.
- Do not park the mixer where it may be exposed to animals (specially rodents) for long
periods of time. The equipment could be damaged and cause injury to livestock.
- Do not allow children to play around the stored unit. Make sure the machine is
parked on a hard and level surface without compromising the safety devices.
- Use the support foot to park the machine horizontally. Remember that this foot can
only support vertical loads.
- If necessary, place the parking wedges on the wheels to prevent the unit from
moving.
Tatoma Ag Equipments Corp. Located in Colcord, OK. Phone (918) 422-4271
- 23 -
