79
PD / PCA / PCA PLUS - Rev. 01 - Jun/22
1. Choose a place as flat as possible. Position the moving support (A) using the jacks
(B).
2. Drive the tractor in reverse gear and approach it to the equipment in a way that is
possible to connect the quick couplers.
3. Slightly move the cylinders to better position the moving support and to facilitate
hitching.
4. Place the junction pin (C) and lock using a cotter pin.
Hitching to the tractor
5. Activate the control valve levers until the cylinders reach their final course. Check
if there is any leak.
6. Fill up the oil reservoir and check the "Minimum" and "Maximum" indications on the
dipstick, being the cylinders totally retreated.
A
A
C
C
B
B
5. Assembly
- Before starting the coupling, be sure that there is no people near the tractor or
equipment. Failure to follow this warning may lead to serious accidents or even
death.
- Precautions when driving:
• Avoid holes, ditches, obstacles and slippery terrains that may cause the tractor
to tip over.
• Avoid steep slopes.
ATTENTION!
