ENGLISH
USE:
-
Connect the appliance to the mains.
-
The display comes on showing the temperature
inside the cavity.
-
Press the lock button during 3 seconds until
hearing a “beep” sound.
-
Press the increase, decrease button to set a
temperature.
-
Let it set for 3 minutes and the appliance will
start generating cold until it reaches the desired
temperature.
SAFETY LOCK:
-
The appliance is lock within 3 seconds of no
operation. Only functions light and temperature
unit change are available without unlocking.
-
To unlock the appliance (Temperature
adjustment) press lock button for 3 seconds.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
-
Unplug the appliance from the mains.
-
Clean the appliance.
TRANSPORT OF THE APPLIANCE
-
Remove all the bottles from the interior.
-
Subject all shelves with tape.
-
Adjust the regulable feet at its lowest position.
-
Close the door and secure its opening cannot be
done while transportation.
-
Transport the appliance in vertical position. It is
advised to wrap the appliance with a blanket or
similar to avoid damages.
-
Ensure that the appliance is noit inclined more
than 45º during transport.
DEFROST FUNCTION
-
This appliance has the Defrost function
configured.
-
Compressor will stop and start to defrost during
45 mins after compressor works with 8 hours
cumulati- vely, avoiding the creation of ice
crystals. Compressor will continue to work and
enters the next 8 hours cumulative cycle after
45mins.
-
During these 45 minutes, water will be
generated inside, which will be collected by the
same wine cooler in the liquid tray (behind the
appliance, above the compressor).
-
This water will disappear and evaporate through
the heat of the compressor.
SPECIAL MESSAGES:
-
The following messages will be error codes that
could be displayed in the appliance screen:
-
EE → It is displayed when the temperature
probe is short-circuited ort disconnected.
-
LL → It is displayed when the temperature
detected inside the cabinet is below 0 ºC.
-
HH → It is shown when the temperature i
s
higher than 37 ºC.
-
In every error, the letters displayed will flash and
the cooling will be stopped until solution.
PRACTICAL ADVICES:
-
Do not introduce hot beverages inside the
appliance. Wait until the beveerages reach the
ambient temperature.
-
Close the door rapidly when using the wine
cooler. Doing this will ensure that the temperatura
change is the mínimum.
-
The wine cooler’s temperatura is always lower
at the upper side and lower at the bottom. Take
care of this when you store your beverages. If you
are going to store different types of wine inside,
please remember to store the white ones at the
upper side and the red ones at the bottom part.
CLEANING
-
Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
-
Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
-
Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products, for
cleaning the appliance.
-
Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of the
appliance.
-
Never submerge the appliance in water or any
other liquid or place it under running water.
