and then dry. CAUTION! Do not immerse electrical
parts of the appliance in any liquid.
4.4. Do not use solvents, or products with an acid
or base pH such as bleach, or abrasive products, for
cleaning the appliance.
4.5. Never submerge the appliance in water or any
other liquid or place it under running water.
5. Anomalies and repair
5.1. Take the appliance to an authorised support
centre if product is damaged or other problems
arise.
5.2. If the connection to the mains has been dam-
aged, it must be replaced and you should proceed as
you would in the case of damage.
6. Troubleshooting guide
6.2. Abnormal conditions:
If the machine experiences an abnormal condition, it
will automatically stop and turn into standby mode.
An Error code will display on the LCD screen.
Overflow of the heating blending jar:
The
spillage
sensor is there for when the liquid
in the blender is too much. When the machine
experiences an overflow, the machine will enter
standby mode.
Remove some liquid and clean the spillage sensor
before continuing.
Note: soup in the heating blender jar cannot exceed
cold state 1600ml hot state 1250ml.
When the LCD displays ‘E02’ it indicates the lid is
properly secured on the blender
26
27
No.
Problem
Reason
Solution
1
Switch not working
The appliance is not
powered on.
Check your connection to
the power supply.
The appliance fails to
start
Press the power switch
2
LCD shows E01
Too much liquid in the jug
blender
Reduce the amount of
liquid
There is some food on
the spillage sensor.
Clean the food off the
spillage sensor
3
LCD show E02
There is not enough liquid
in the jug.
Add more liquid
The jug blender cover is
not correctly fitted.
Ensure the jug blender lid
is properly fitted.
4
LCD show E03
Attachments incorrectly
assembled.
Assemble attachments
according to user manual.
