3.2.3.4. Then fit the adjustable slicer disc(14) onto
the Shaft(16). You can also fit the Coarse & fine
shredding disc(17), the French fry disc(18), the
Dough kneader(19), the Chopping blade(20) or the
Whisk holder(21) as desired. (The Egg whisk(22)
must be inserted into the Whisk holder(21) before
fitting the Whisk holder(21) onto the Shaft(16).
Fit the Food processor lid(13) onto the Food proces-
sor bowl(15) as the picture shows. Ensuring the top
of the Shaft(16) locates into the centre of the Food
processor lid(13)
Then turn the Food processor lid(13) in a clockwise
direction, until it locks.
Reverse the above procedure to disassembly the
Food processor bowl(15), if necessary.
Once assembled and ready for use, use the control
knob to select your desired speed.
3.2.4, Assembling the citrus press(23)
3.2.4.1. Fit the Shaft(16) and the Food processor
bowl(15) onto the Motor unit(4) following the above
instructions.
Fit the Strainer(24) on the Food processor bowl(15)
as the picture illustrates.
3.2.4.2. Turn the Strainer (24)in a clockwise direc-
tion, until it locks.
Place the Citrus press(23) over the Shaft(16). Turn-
ing the Citrus press until it drops all the way down.
Press the citrus fruit onto the cone.
Use the lowest speed setting for this.
Take care not to press your hand directly onto the
cone as the motor is powerful and it may cause
injury.
3.2.5. Taking apart the juicer extractor
A- Take out the Juicer pusher.
B- Pull at the bottom of the hooks.
C- Pull the hooks upwards; Then you can take off
the Juicer cover, the Juicer filter and the Juicer bowl
in sequence if necessary.
D- Reverse the above process to refit the juice
extractor if necessary.
3.2.6. Assembling the juice extractor
3.2.6.1. Place the juice extractor on the motor
unit(4).
