Taurus 915512000, Manual

FINISHED USING THE APPLIANCE:

 -Stop the appliance by releasing the pressure 

on the buttons.

 -Unplug the appliance from the mains.
 -Clean the appliance.

CLEANING

 -Disconnect the appliance from the mains and 

allow it to cool before undertaking any cleaning 

task.

 -Clean the equipment with a damp cloth with a 

few drops of washing-up liquid and then dry.

 -Do not use solvents, or products with an acid or 

base pH such as bleach, or abrasive products, 

for cleaning the appliance.

 -Do not let water or any other liquid get into the 

air vents to avoid damage to the inner parts of 

the appliance.

 -Never submerge the appliance in water or any 

other liquid or place it under running water.

 -During the cleaning process, take special care 

with the blades, as they are very sharp.

 -It is advisable to clean the appliance regularly 

and remove any food remains.

 -If the appliance is not in good condition of 

cleanliness, its surface may degrade and 

inexorably affect the duration of the appliance’s 

useful life and could become unsafe to use.

 -Neither parts of this appliance are suitable for 

cleaning in the dishwasher.

 -The following pieces may be washed in hot 

soapy water:

 -Shield – pusher.
 -Foldable platform.

 -To remove the platform, fold the platform and 

extract by pulling the bottom left-hand.

 -The cutting guide can be removed to clean by 

turning the regulator counterclockwise.

 -The blade, sliding carriage and body can be 

cleaned with a slightly moistened cloth.

 -Then dry all parts before its assembly and 

storage.

 -To place the platform, first fit on the right side 

and then press on the left side.

 -From time to time it is convenient to remove the 

blade for a more through cleaning. To do so, 

turn the axle of the blade to the right about 90º 

and take it out with care.

 -With a soft sponge or cloth, clean both sides of 

the blade with soap and water. Rinse and dry 

the blade.

 -To replace the blade, place it back into position, 

hold the tab and align the blade with the trans-

mission gears until it fits snugly. Turn tab in the 

opposite direction to tighten the blade.