- Do not obstruct the opening of the door of the
appliance.
- The socket should be easily accessible in order
to be able to quickly disconnect the appliance in
case of an emergency.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all products’ packaging has been
removed.
- Before using the product for the first time, clean
the parts that will come into contact with food in
the manner described in the cleaning section.
- It is recommended that you wait for a minimum
of 2 hours after having installed the appliance
before you use it for the first time, leaving the
front cover open.
FILLING WITH WATER:
- You must fill the water compartment before
turning on the appliance.
- Open the cover.
- Detach the deposit from the appliance (G)
- Fill the compartment with cold water.
- Fill the deposit taking care to observe the MAX
level.
- Put the deposit back into its housing, ensuring
that it is inserted properly.
- Close the lid.
USE:
- Unroll the cable completely before plugging it in.
- Connect the appliance to the mains.
- Turn the appliance on, by using the on/off button
(1).
- The processing time is approximately 7-12
minutes (depending on water temperature and
room temperature). Caution: The ice cubes
produced may be small and irregular during the
first 3 cycles.
- Caution: the cubes may not be fully transpa-
rent, due to the air entering during processing
development but this does not alter the quality
of the cubes.
- When the water tank is empty, the «Tank emp-
ty» light (4) will light up in red and a beep will
sound for a few seconds.
- Turn off the appliance.
- Fill tank while observing the maximum level.
- Wait 3 minutes before running the appliance
again.
- When the ice cube tray is full, the «Tray full»
light (3) will light up and several beeps will
sound.
- Drain the ice cube tray with the help of the
spoon supplied with the appliance.
- Never leave the ice tray full while the appliance
is in use.
- To completely empty the water tank, open the
drain plug (A) located inside the tank, ensuring
that there is a container underneath the applian-
ce. Once the tank is emptied, replace the plug
(A) in the tank.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- After use, press the start/stop button to turn off
the appliance.
- Unplug the appliance from the mains.
- Remove the water from the inside of the
appliance.
- Drain and dry the water tank before storing the
appliance if you are not going to use it for an
extended period of time.
- Clean the appliance.
SAFETY THERMAL PROTECTOR:
- The appliance has a safety device, which pro-
tects the appliance from overheating.
- If the appliance turns itself off and does not
switch itself on again, disconnect it from the
mains supply, and wait for approximately 15
minutes before reconnecting. If the machine
does not start again seek authorised technical
assistance.
CLEANING
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- Never submerge the connector in water or any
other liquid or place it under running water.
- Then dry all parts before its assembly and
storage.
