tended if is not in use. This saves energy and prolongs
the life of the appliance.
3. Instructions for use
3.1. Before first use:
3.1.1. During transportation, the incline angle of the
cabinet should not be over 45° .Do not turn the ice
maker upside down. As this may damage the compres-
sor and sealed system.
3.1.2. Remove all packing material and carefully check
your ice maker to ensure it is in good condition and
that there is no damage to the ice maker or power cord
and plug.
3.1.3. The ice maker should be placed horizontally on
a level surface.To ensure proper ventilation for your ice
maker allow 150mm of space at the top, the back and
on each side. Do not install the ice maker near an oven,
radiator, or any other heat source.
3.1.4. Before using the ice maker for the first time,
please wait 2 hours after positioning it, and keep the
front lid open for at least 2 hours.
3.1.5. Ensure that the voltage indicated on the ice
maker corresponds with the voltage in your home.
3.2. Use and care
:
Control Panel Operation:
ON/OFF
: Press it to turn unit on or off.
ADD WATER:
This light will come on with a long noise
‘DI’ noise. You will need to add water and press the
‘OFF’ then the ‘ON’ button to restart the ice maker.
ICE FULL:
This light will come on with a ‘DI, DI’ noise
when the ice has reached the maximum capacity of the
storage cabinet. Press ON/OFF button to restart the
ice maker after some of the ice has been taken away.
3.3. Operating Instructions:
Step 1.Open the lid and fill the water reservoir with
water.
Note:
Make sure the water level in the water reservoir
is not over the Ice collecting tray.
Step 2.
Connect to the power.
Step 3.
Press ON/OFF button to turn unit on. The ice maker
begins to work.
Note:
For the first three cycles,the ice may be small
and irregular in size.
Step 4
If indicator ADD WATER is red with ‘DI’ noise,then take
out the basket,then add water as per step 1, then press
ON/OFF to
restart the ice maker
Note
:If no water is pumped up to the water tray over
two cycles but the water in water tank is enough, then
please move the unit ahead a little,then remove the
silicon stopper,and let several drops water run out.
Step 5
If indicator ICE FULL is in red with ‘DI DI’ noise,please
take out the ice with the scoop.
Note:
When the ice collecting tray is full please remove
the ice immediately, Do not allow the ice collecting tray
to overfill.
Step 6
Press ON/OFF button to stop the machine.
3.3 Once you have finished using the appliance:
3.3.1. Allow appliance to cool down.
3.3.2. Unplug the appliance from the mains power
supply.
3.3.3. Clean the appliance as described in the cleaning
section.
4. Cleaning and Maintenance
Clean the inner liner, ice collecting tray, water box,
ice shovel and evaporator frequently. When cleaning,
unplug the unit and remove the ice cubes. Use a diluted
solution of water and vinegar to clean the inside and
the outside surface of the ice maker. Do not spray ice
maker with chemicals or diluted agents such as acids,
ICE FULL
ICE
ADD WATER
ON/OFF
997150_IM.indd 3
2018/01/15 11:14:02 AM
