14
After Sales Support
EMAIL: service.australia@einhell.com
TEL: 1300 922 271
to use a bit that matches the screw in shape and size. Set
the torque, as described in section 6.1 in these operating
instructions, to suit the size of screw.
4.6.7 Selecting 1st gear to 2nd gear (Fig. 3/Item 6)
By adjusting the selector switch (6), you can work with a faster
or slower turning speed. Change the gear only when the drill
is at a standstill. If you fail to observe this point, the gearing
may be damaged.
4.7. CLEANING, MAINTENANCE
AND ORDERING OF SPARE
PARTS
Always remove the battery pack before starting any cleaning
work!
4.7.1 Cleaning
•
Keep all safety devices, air vents and the motor housing
free of dirt and dust as far as possible. Wipe the
equipment with a clean cloth or blow it with compressed
air at low pressure.
•
We recommend that you clean the device immediately
each time you have finished using it.
•
Clean the equipment regularly with a moist cloth and
some soft soap. Do not use cleaning agents or solvents;
these could attack the plastic parts of the equipment.
Ensure that no water can seep into the device.
4.7.2 Maintenance
There are no parts inside the equipment which require
additional maintenance.
4.7.3 Ordering spare parts
Contact our After Sales Support on 1300 922 271 and quote
the following data when ordering spare parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Spare part number of the part required
4.8. DISPOSAL AND RECYCLING
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material and can
therefore be reused or can be returned to the raw material
system.
The unit and its accessories are made of various types of
material, such as metal and plastic. Defective components
must be disposed of as special waste. Ask your local council.
4.9. STORAGE
Store the equipment and accessories out of children’s reach in
a dark and dry place at above freezing temperature. The ideal
storage temperature is between 5 and 30 °C. Store the electric
tool in its original packaging.
