22
After Sales Support
EMAIL: service.australia@einhell.com
TEL: 1300 922 271
runs smooth.
•
Before you press the On/Off switch (2), make sure that the
saw blade is correctly fitted and that moving parts run
smoothly and the clamping screws are tightened securely.
5.6.5 Using the laser (Fig. 12 / Item 14)
The laser (14) switches on automatically when the On/Off
switch (2) is pressed.
5.7. CLEANING, MAINTENANCE
AND ORDERING OF SPARE
PARTS
Always remove the battery pack before starting any cleaning
work!
5.7.1 Cleaning
Keep all safety devices, air vents and the motor housing free
of dirt and dust as far as possible. Wipe the equipment with a
clean cloth or blow it with compressed air at low pressure.
We recommend that you clean the device immediately
each time you have finished using it. Clean the equipment
regularly with a moist cloth and some soft soap. Do not use
cleaning agents or solvents; these could attack the plastic
parts of the equipment. Ensure that no water can seep into
the device.
5.7.2 Maintenance
There are no parts inside the equipment which require
additional maintenance.
5.7.3 Ordering spare parts
Please contact our After Sales Support on 1300 922 271 and
quote the following data when ordering spare parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Spare part number of the part required
5.8. DISPOSAL AND RECYCLING
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material and can
therefore be reused or can be returned to the raw material
system.
The unit and its accessories are made of various types of
material, such as metal and plastic.
Defective components must be disposed of as special waste.
Ask your local council.
5.9. STORAGE
Store the equipment and accessories out of children’s reach in
a dark and dry place at above freezing temperature. The ideal
storage temperature is between 5 and 30 °C. Store the electric
tool in its original packaging.
