N
E
4. Hang the body of the extractor hood and with
the filters removed you will see two more fixing
points. You must mark these two points,
remove it and repeat what has been done
previously (drill and place studs). We hang
again the extractor hood and fix two more 4X30
mm screws.
5. Now that the hood is hung, you must fix the
one-way valve to the air outlet as follows:
6. Connect the exhaust pipe to the air outlet of
the extractor hood as follows:
NOTE
: It is recommended to use American
tape to fix and better seal the exhaust pipe
around the air outlet.
7. Place the lower chimney on the hanged
hood with the small chimney hanger placed on
the back, mark two points on the wall in the
position of the chimney hanger holes.
8. Remove the lower chimney and drill two 8
mm holes and fix the small chimney hanger
with two screw plugs and two screws.
9. Place the upper chimney in the lower
chimney and place them over the hood and
hang the lower chimney on the small chimney
hanger.
10. Pull the upper chimney up until it reaches
the required height and mark the points of the
large chimney hanger on the wall.
11. Drill two 8 mm holes and secure the large
chimney hanger with two screw plugs and two
screws.
Summary of Contents for G60BKAL
