Taurus RAPIDISSIMO CLEAN PRO, Manual

 -6. Never direct the jet of steam at people, 

animals or devices that have electrical compo-

nents.

 -7. Only use the measuring beaker to fill the 

water tank.

 -8. To protect against the risk of electrical 

shock, do not immerse the steam cleaner / fab-

ric steamer in water or other liquids, or handle it 

with wet hands.

 -9. Never tug on the power cord to disconnect it 

from the power outlet. Hold the plug and pull it 

out to disconnect it.

 -10. Disconnect the appliance when it is not in 

use.

 -11. Do not operate the steam cleaner/fabric 

steamer if the cable is damaged or if the appli-

ance has been dropped or is damaged

 -12. Touching the hot parts, the hot water or the 

steam that the cleaner generates may cause 

burns. Always be cautious when there is hot 

water in the tank.

FILLING THE TANK WHILE USING THE 

CLEANER

 -Make sure that the appliance is unplugged.
 -Unscrew the safety cap (3), fit the funnel in the 

tank hole and fill it with 1 measure of the beak-

er (6) (Fig. A). Remember that the water should 

not go above the mark on the beaker.

 -

S

crew the safety cap (3).

 -Plug in the steam cleaner and wait for the pilot 

light to go off, telling you that the appliance is 

ready for use.

 -IMPORTANT NOTE: Never refill the water tank 

when the appliance is plugged into the wall 

outlet.

USER INSTRUCTIONS

 -Connect the required cleaning attachment and 

plug in the appliance.

 -The pilot light (5) will come on indicating that 

the appliance is plugged in.

 -When the steam cleaner has the pressure 

required to operate, the pilot light (5) will go 

off indicating that you can start to use it. This 

operation will take approximately 5 minutes. 

During use, the warning light will go off and 

then come on, indicating that the steam cleaner 

is recovering the necessary pressure.

 -We recommend pressing the control (2) 

repeatedly for short bursts rather than just a 

few times for longer periods, so as to maintain 

pressure in the reservoir.

 -When finished using the steam cleaner, set the 

on/off switch to the off position and discon-

nect the device from the mains, wait for it to 

cool down to remove the attachments.

ATTACHMENTS
TAPER NOZZLE (10)

 -Insert the taper nozzle (10) in the mouth (4) by 

lining up the lugs on the taper nozzle with the 

holes in the mouth (4) and turn it clockwise as 

far as it will go (Fig. B).

ROUND BRUSH (8) AND ANGLE NOZZLE (9)

 -Fit these accessories in the taper nozzle (10) or 

flexible hose (14) (Fig. D and E).

FLEXIBLE HOSE (14)

 -If you want to reach inaccessible places or 

the area to be cleaned is too far away, use the 

flexible hose.

 -Fit the hose on the appliance as explained for 

fitting the taper nozzle (10).

 -Fit any of the accessories accompanying the 

appliance to the hose, from the flat side.

WINDOW AND FABRIC CLEANING 

ACCESSORIES (11-12)

 -Use these accessories for cleaning floors, win-

dows, furniture, sofas, fabrics, and so on.

 -The cloth (13) can be used for cleaning such 

delicate surfaces as sofas and armchairs.

ONCE YOU HAVE FINISHED USING THE 

APPLIANCE:

 -Unplug the appliance to the mains.
 -Leave the appliance to cool down.
 -Empty the water out of the boiler. Make sure 

the appliance is completely depressurized 

before opening of the safety cap.

CLEANING

 -Disconnect the appliance from the mains and 

allow it to cool before undertaking any cleaning 

task.

 -Clean the equipment with a damp cloth with a 

few drops of washing-up liquid and then dry.

 -Do not use solvents, or products with an acid or 

base pH such as bleach, or abrasive products, 

for cleaning the appliance.

 -Never submerge the appliance in water or any 

other liquid or place it under running water.