15
Step 2:
Assembly of the console mast
1. Move the console mast cover (41) as far as possible on the console mast (10).
L
NOTICE
Make sure that the console mast cover (41) points in the correct direction.
2. On the upper opening of the frame (1), you will find a console cable (32). Unwind the console
cable (32) and smooth it out in order to then thread it from the bottom to the top through the
console mast (10).
3. Assemble the console mast (10) on the designated bracket on the frame (1) with four hexagon
bolts (70), four washers (97), two hexagon bolts (70) and two spring washers (102).
࣑
ATTENTION
Be careful not to pinch the cables in the following step.
4. Mount the console (31) on the console mast (10) with the four screws (78) pre-mounted on the
bracket.
5. On the upper opening of the console mast (10), there are three cables, two hand pulse cables
(37) and a console cable (32). Connect this cable with the corresponding cables on the backside
of the console (31).
L
NOTICE
The plugs are arranged so that they cannot be incorrectly inserted in each other.
6. First store the excess cable in the console mast (10). Then fasten the console (31) on the console
mast (10) with four M5 x 10mm screws (78).
7. Tighten all screws with the tool.
Summary of Contents for X71
