10
taylormadeproducts.com/aquafi
574-534-7521
aquafisupport@lci1.com
Rev:08.01.19
AquaFi
™
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0002558
FCC Compliance
FCC 15B statement
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the
FCC Rules� These limits are designed to provide reasonable
protection against harmful interference in a residential
installation� This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications� However, there is no guarantee that
interference will not occur in a particular installation� If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna�
• Increase the separation between the equipment
and receiver�
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected�
• Consult the dealer or an experienced radio/TV technician for help�
FCC Part 15 compliance statement
This device complies with part 15 of the FCC Rules�
LED Status Chart
LED Color What is happening?
Why?
What should be done?
Blue
System is booting up�
System was off�
Nothing� This is normal�
Green
Successful network connection�
No previous network
connection�
Nothing� This is normal�
Red
No service�
Out of carrier’s service
coverage area�
Relocate within carrier’s coverage area�
No SIM card�
Missing or damaged SIM card�
Replace SIM card�
2G or less connection�
Weak service area�
Relocate within a stronger service area�
Incorrect APN information�
Access Point Name (APN) has
been changed or blocked�
Contact Taylor Made Products�
No color
No power�
Hotspot not fully seated in its
mounting dock�
Remove hotspot from mounting dock, then
reinsert into dock�
Make sure hotspot and dock clamps are fully
engaged, creating a good electrical connection�
Main power off�
Turn main power on�
Obstruction between electrical
contacts�
Clear any obstruction from between the
mounting dock and hotspot electrical contacts�
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation�
IC User manual notice
This device contains license-exempt transmitter(s)/receiver(s)
that comply with Innovation, Science and Economic
Development Canada’s license-exempt RSS(s)� Operation is
subject to the following two conditions:
• This device may not cause interference�
• This device must accept any interference, including
interference that may cause undesired operation
of the device�
Non-modification Warning
Any changes or modifications to this device not expressly
approved by the party responsible for compliance could void the
user’s authority to operate this equipment�
RF Exposure Statement
This equipment complies with FCC/IC radiation exposure
limits set forth for an uncontrolled environment and meets
the FCC radio frequency (RF) Exposure Guidelines and
RSS-102 of the IC radio frequency (RF) Exposure rules�
This equipment should be installed and operated keeping
the radiator at least 30cm or more away from person’s body�
