3-2
SAFETY
Model 0736
Safety
3
•
For Cord-Connected Machines:
Only
authorized Taylor service technicians or
licensed electricians may install a plug or
replacement cord on the machine.
•
Stationary machine which are not equipped with
a power cord and a plug or another device to
disconnect the machine from the power source
must have an all-pole disconnecting device with
a contact gap of at least 0.125 in. (3 mm)
installed in the external installation.
•
Machines that are permanently connected to
fixed wiring and for which leakage currents may
exceed 10 mA, particularly when disconnected
or not used for long periods, or during initial
installation, shall have protective devices to
protect against the leakage of current, such as a
GFI, installed by the authorized personnel to the
local codes.
•
Supply cords used with this machine shall be
oil-resistant, sheathed flexible cable not lighter
than ordinary polychloroprene or other
equivalent synthetic elastomer-sheathed cord
(code designation 60245 IEC 57) installed with
the proper cord anchorage to relieve conductors
from strain, including twisting, at the terminals
and protect the insulation of the conductors from
abrasion.
•
If the supply cord is damaged, it must be
replaced by the manufacturer, service agent, or
a similarly qualified person, in order to avoid a
hazard.
Failure to follow these instructions may result in
electrocution. Contact your local Taylor distributor for
service.
CAUTION!
This machine is designed to
maintain product temperature under 41°F (5
C). Any
product being added to this machine must be below 41
F
(5
C). Failure to follow this instruction may result in
health hazards and poor machine performance.
Do not
obstruct air intake and discharge openings: A
minimum of 6 in. (152 mm) on both sides, and 0 in.
(0 mm) in the rear is required. Install the skirt provided on
the right side of the unit. Failure to follow this instruction
may cause poor freezer performance and damage to the
machine.
This freezer is designed to operate indoors under normal
ambient temperatures of 70
F to 75
F (21
C to 24
C).
The freezer has successfully performed in high ambient
temperatures of 104
F (40
C) at reduced capacity.
Do not
run the machine without product. Failure to follow
this instruction can result in damage to the machine.
Noise Level:
Airborne noise emission does not exceed
78 dB(A) when measured at a distance of 3.3 ft. (1.0 m)
from the surface of the machine and at a height of 5.25 ft.
(1.6 m) from the floor.
Machine Warning Labels
Rear Panel Warning Label
Do not operate the freezer without reading this
Operator’s Manual
This machine has many sharp edges that can cause
severe injuries. Do not touch with hands, clean with
brush/vacuum cleaner.
Only authorized Taylor service personnel should perform
installation and repairs on this machine.
DANGER:
High Voltage inside: danger of electrocution.
Disconnect the power supply before servicing the
machine.
CAUTION:
Hazardous moving parts; the machine can
start automatically. Do not operate with panels removed,
disconnect the electrical supply before servicing the
machine.
DANGER:
Hot parts, risk of burns. Hot product, do not
draw during heating treatment.
!
Summary of Contents for 0736
