Taylor 104 Operator'S Manual Download

Page: 5 / 40

Section 1

1-1

Model 104

To the Installer

The following information has been included in the
manual as safety and regulatory guidelines. For complete
installation instructions, please see the Installation
Checklist.

Installer Safety

IMPORTANT!

In all areas of the world,

equipment should be installed in accordance with
existing local codes. Please contact your local authorities
if you have any questions.

Care should be taken to ensure that all basic safety
practices are followed during the installation and
servicing activities related to the installation and service

of Taylor

machines.

•

Only Taylor service personnel should perform

installation, maintenance, and repairs on Taylor
machines.

•

Authorized service personnel should consult

OSHA Standard 29CFRI910.147 or the
applicable code of the local area for the industry
standards on lockout/tagout procedures before
beginning any installation or repairs.

•

Authorized service personnel must ensure that

the proper protective equipment (PPE) is
available and worn when required during
installation and service.

•

Authorized service personnel must remove all

metal jewelry, rings, and watches before
working on electrical equipment.

DANGER!

The main power supply(s) to the

machine must be disconnected prior to performing any
installation, maintenance, or repairs. Failure to follow this
instruction may result in personal injury or death from
electrical shock or hazardous moving parts as well as
poor performance or damage to the machine.

Note:

All repairs must be performed by a Taylor service

technician.

WARNING!

This machine has many sharp

edges that can cause severe injuries.

Site Preparation

Review the area where the machine will be installed
before you uncrate the machine. Make sure that all
possible hazards the user or equipment may come into
contact with have been addressed.

WARNING

! Only install this machine in a

location where its use and maintenance is restricted to
trained personnel. Failure to comply may result in
personal injury.

For Indoor Use Only:

This machine is designed to

operate indoors, under normal ambient temperatures of



F to 75

F (21

C to 24

C). The freezer has

successfully performed in high ambient temperatures of
104

F (40

C) at reduced capacities.

WARNING!

This machine must

NOT

installed in an area where a water jet or hose can be
used.

NEVER

use a water jet or hose to rinse or clean

the machine. Failure to follow this instruction may result
in electrocution.

CAUTION!

This machine must be installed on

a level surface to avoid the hazard of tipping. Extreme
care should be taken in moving this machine for any
reason. Two or more persons are required to safely move
this machine. Failure to comply may result in personal
injury or damage to the machine.

The authorized installer should inspect the machine for
damage and promptly report any damage to the local
authorized Taylor distributor.

This machine is made using USA sizes of hardware. All
metric conversions are approximate and vary in size.