7
Horizontal
Mount
Vertical /
Upright
Mount
'AA'
'AA'
Short
Cord
Housing
Remote
Sensor
Mounting
Tube
Assembling Instructions
1.
Properly align the compass and
wind cup sensor together to create
the wind base; do not press too
hard otherwise damage may occur.
Insert the connector tube to the
bottom of the wind cup sensor and
fasten with an M3x22 screw with nut
(included).
2.
Plug the shorter cord into the port
located on the bottom of the wind
cup sensor.
3.
Thread the longer cord into the
housing through the opening.
4.
Connect the wind base and top of
housing and fasten with an M3x22
screw with nut (included).
5.
Remove battery compartment
cover on the remote sensor and
insert 2 AA batteries. Replace
battery compartment cover.
6.
Connect the plastic mounting tube
into the base. Thread an M3x25
screw with nut (included) through
the aligned openings and tighten.
7.
Depending upon vertical or
horizontal orientation, connect the
transmitter to the plastic mounting
tube and fasten together with an
M3x18 screw (included).
8.
Plug the long cord from the housing
into the port marked “Wind”.
9.
Carefully slide the remote sensor
with the mounting tube into the
housing.
Note: The Wind Gauge
Remote Sensor can be
mounted in 2 different
ways as shown here.
