Taylor C001, Operator'S Manual

6-4  

OPERATING PROCEDURES

Models C001 and C002 

Operating Procedures 

6 

8. Place the assembled flow regulator into the hopper 

for sanitizing.

9. Install the rear bearing drip pan.

10. Put the sanitized hopper gasket on the hopper cover.

Figure 6-14

Repeat these steps for the other side of the freezer.

Sanitizing

1. Prepare an approved 100 ppm sanitizing solution 

(examples: 2-1/2 gal. [9.5 L] of Kay- 5® or 2 gal. 



[7.6 L] of Stera-Sheen®). 

Use warm water and 

follow the manufacturer’s specifications.

2. Pour the sanitizing solution into the hopper.

3. While the solution is flowing into the freezing cylinder, 

brush-clean the mix hopper. When cleaning the 
hopper, take particular care in brushing the mix inlet 
hole and the flow regulator.

4. Place an empty pail under the draw plate. The pail 

can be hung from the handscrews on the freezer 
door.

5. Place the DASHER switch in the ON position for 5 

minutes.
In order to avoid having sanitizer splash out when the 
draw plate is opened, place the DASHER switch in 
the OFF position. Open the draw plate and place the 
DASHER switch in the ON position. Drain the 



sanitizer into an empty pail. Place the DASHER 
switch in the OFF position and close the draw plate.

KEEP FINGERS OUT OF FILL AND 

DISCHARGE OPENINGS.

 Failure to do so may result in 

severe personal injury, contaminated product, or 
component damage.

Repeat these steps for the other side of the freezer.

Priming for Continuous Run

1.

With sanitized hands,

 remove the flow regulator 

assembly from the mix hopper and set it on a clean, 
dry surface. Place an empty pail under the draw 
plate.

2. Pour 1 to 2 cups (1/2 L) of mix into the hopper to 

remove the remaining sanitizing solution from the 
freezing cylinder.

3. Open the draw plate on the freezer door and place 

the DASHER switch in the ON position.

Repeat steps 1 - 2 for the other side of the freezer.

KEEP FINGERS OUT OF FILL AND 

DISCHARGE OPENINGS.

 Failure to do so may result in 

severe personal injury, contaminated product, or 
component damage.

4. Install the large hopper cover on the hopper.

5.

With sanitized hands,

 install the flow regulator 

through the hopper cover. Align the flow regulator 
with the slots on the hopper cover. The flow regulator 
can be positioned to allow the numbers to be read 
from the front, back or either side.

6. Pour mix into the hopper and fill it to 1/2 in. (13 mm) 

below the air inlet on the flow regulator.

7. Place the FREEZE/CHILL switch in the FREEZE 

position and the HOPPER REFRIGERATION switch 
in the ON position.

8. Allow the machine to run for 2 minutes. Set the flow 

regulator between S - 1.

9. Install the small hopper lid.

Repeat steps 4 - 9 for the other side of the freezer.

17042