ENGLISH - 10
AUTOMATIC PRODUCTION pushbutton
In the AUTOMATIC PRODUCTION function, the machine operates a
batch freezing cycle until the consistency value of 240 is reached or
until the ice-cream stops increasing its consistency within the
sampling interval, which has been set in the electronic card (see
Chapter 6.2.2.1).
Once the cycle has been completed, the machine will switch
automatically to the preservation function. Let the compressor run
two or three cycles to increase the product maximum consistency
even further and to obtain consequently a drier and more compact
ice-cream.
Press the pushbutton pictured on the left to switch to the
AUTOMATIC PRODUCTION mode: the agitator motor will start at
reduced speed and after a few seconds the compressor motor, the
motor ventilating fans (only for machines with air condensating
system) and the electronic module for consistency control start up
too; the electronic module allows reaching the ideal level of batch
freezing, independently of the kind of mixture used, on condition that
it is within the minimum and maximum quantities allowed for the
machine capacity.
The following safety devices are all enabled: door safety catch, batch
freezing safety timer, control for lack of growth in consistency and the
emergency signals.
SEMI-AUTOMATIC PRODUCTION pushbutton
In the SEMI-AUTOMATIC PRODUCTION function, the operator can
set a value for the maximum consistency. This is especially useful
for special batch freezing or when the operator is not fully satisfied
with the results obtained with the AUTOMATIC cycle.
Press the SEMI-AUTOMATIC pushbutton to switch to the SEMI-
AUTOMATIC mode and set the required consistency value (see
Chapter 5.3.2); confirm the set value and the agitator motor starts at
reduced speed and after a few seconds the compressor motor, the
motor ventilating fans (only machines with air condensating system)
and the electronic module for consistency control start up too.
The following safety devices are all enabled: door safety catch, batch
freezing safety timer, control for lack of growth in consistency and the
emergency signals.
