ENGLISH - 14
6. MAINTENANCE
6.1 ROUTINE MAINTENANCE
During production, cleaning and maintenance operations, never touch the machine with
hands or tools without making sure that the machine has been disconnected from mains.
In case of troubles, make sure that they are not caused by a lack of servicing. On the
contrary, ask for the intervention of a FRIGOMAT customer service. In case it is necessary
to replace a piece, always ask a distributor or an authorized retailer for ORIGINAL spare
parts.
It is advisable to make the machine be checked by a Customer Service every 6/8 months.
6.1.1 CLEANING AND SANITIZATION
Bacteria and moulds easily proliferate due to the presence of fats in cream, that is why it is
necessary to carefully wash and clean all parts in contact with the product, such as the
cylinder, the agitator and the door.
Rustless materials and/or made of plastic for food
industry used for our machines, in conformity with the
most severe international standards, make washing
operations easier, however they cannot prevent mould
proliferation, etc. caused by insufficient cleaning.
TAYLOR COMPANY recommends cleaning the tank
and the parts in contact with the product after the
employment and in any case in compliance with the
sanitary standards in force in the country of
installation. To thoroughly clean your batch freezer,
proceed as follows:
1. Pour approximately 15.8 quart (15 litres) of clean
cold water into the cylinder for model C116, 10.5
quart (10 litres) for model C117, 6.3 quart (6 litres)
for model C118.
2. Press the CLEANINING pushbutton and let the
machine run for a few minutes. Press STOP and
let the washing water off. Repeat the operation
until the water coming out of the cylinder is clean.
3. Pour approximately 15.8 quart (15 litres) of
detergent solution/sanitiser into the cylinder for
model C116, 10.5 quart (10 liters) for model C117
and 6.3 quart (6 liters) for model C118.
4. Press the CLEANINING pushbutton and let the
machine run for a few minutes. Press and let all
the solution off.
5. To disassemble the door, pull up the lever, make
the door rotate to the left and, whilst holding it with
one hand, remove the hinged knob with the other
