Taylor C300 NP, Operator'S Manual

Section 3

3-1 

Model C300

Safety 

 3

Safety

We, at Taylor Company, are concerned about the safety 

of the operator when he or she comes in contact with the 

freezer and its parts. Taylor has gone to extreme efforts to 

design and manufacture built-in safety features to protect 

both the operator and the service technician. As an 

example, warning labels have been attached to the 

freezer to further point out safety precautions.

DANGER! 

Failure to adhere to the following 

safety precautions may result in severe personal injury or 

death. Failure to comply with these warnings may also 

damage the unit and/or its components. Such damage 

may result in component replacement and service repair 

expenses

.

NOTICE! DO NOT

 operate this machine 

without reading this entire manual first. Failure to follow 

all of these operating instructions may result in damage 

to the machine, poor performance, health hazards, or 

personal injury.

IMPORTANT! 

This appliance is to be used 

only by trained personnel. It is not intended for use by 

children or people with reduced physical, sensory, or 

mental capabilities, or lack of experience and knowledge. 

Where limited equipment operation is allowed for public 

use, such as a self-serve application, supervision or 

instruction concerning the use of the appliance by a 

person responsible for their safety is required. Children 

should be supervised to ensure that they do not play with 

the appliance.

IMPORTANT! 

An equipotential grounding lug is 

provided with this unit. Some countries require the 

grounding lug to be properly attached to the rear of the 

frame by the authorized installer. The installation location 

is marked by the equipotential bonding symbol (5021 of 

IEC 60417-1) on both the removable panel and the unit's 

frame.

WARNING! DO NOT

 use a water jet to clean or 

rinse the machine. Failure to follow these instructions 

may result in serious electrical shock.

WARNING!

 Avoid injury.

•

DO NOT

 operate this machine unless it is 

properly grounded.

•

DO NOT

 operate this machine with larger fuses 

than specified on the machine's data label.

•

All repairs should be performed by an 

authorized Taylor service technician.

•

The main power supplies to the machine must 

be disconnected prior to performing installation, 

repairs, or maintenance.

•

Machines that are permanently connected to 

fixed wiring and for which leakage currents may 

exceed 10 mA, particularly when disconnected 

or not used for long periods, or during initial 

installation, shall have protective devices to 

protect against the leakage of current, such as a 

GFI, installed by the authorized personnel to the 

local codes.

•

Stationary machines which are not equipped 

with a power cord and a plug or another device 

to disconnect the appliance from the power 

source must have an all-pole disconnecting 

device with a contact gap of at least 0.125 in. (3 

mm) installed in the external installation.

•

Supply cords used with this machine shall be 



oil-resistant, sheathed flexible cable not lighter 

than ordinary polychloroprene or other 

equivalent synthetic elastomer-sheathed cord 

(code designation 60245 IEC 57) installed with 

!

!