3-2
SAFETY
Model C300
Safety
3
the proper cord anchorage to relieve conductors
from strain, including twisting, at the terminals
and protect the insulation of the conductors from
abrasion.
•
If the supply cord is damaged, it must be
replaced by an authorized Taylor service
technician in order to avoid a hazard.
Failure to follow these instructions may result in
electrocution. Contact your local authorized Taylor
distributor for service.
WARNING!
Avoid injury.
•
DO NOT
allow untrained personnel to operate
this machine.
•
DO NOT
operate the machine unless all service
panels and access doors are restrained with
screws.
•
DO NOT
remove any internal operating parts
(including, but not limited to, freezer door,
beater, or scraper blades), unless all control
switches are in the OFF position.
Failure to follow these instructions may result in severe
personal injury, especially to fingers or hands, from
hazardous moving parts.
WARNING!
This machine has many sharp
edges that can cause severe injuries.
•
DO NOT
put objects or fingers in the door
spout. This may contaminate the product and
cause severe personal injury from blade
contact.
•
USE EXTREME CAUTION
when removing the
beater assembly. The scraper blades are very
sharp.
CAUTION!
This machine must be placed on a
level surface. Extreme care should be taken when
moving the for any reason. Two or more persons are
required to safely move this machine. Failure to comply
may result in personal injury or damage to the machine.
IMPORTANT!
Access to the service area of
the machine must be restricted to persons having
knowledge and practical experience with the machine, in
particular as far as safety and hygiene are concerned.
NOTICE!
Cleaning and sanitizing schedules
are governed by your federal, state, or local regulatory
agencies and must be followed accordingly. Please see
the cleaning section of this manual for the proper
procedure to clean this machine.
WARNING!
This unit is pressurized when in
operation. The control switch must be in the OFF position
until the unit is completely assembled. No part should
ever be removed from the machine while it is in operation.
No parts should be removed until the control switch has
been turned to the OFF position.
•
DO NOT
allow untrained personnel to operate this
machine.
•
DO NOT
operate the freezer unless all service panels
and access doors are restrained with screws.
•
DO NOT
remove any internal operating parts
(example: freezer door, beater, scraper blades, etc.)
unless all control switches are in the OFF position.
Failure to follow this instruction may result in severe
personal injury from hazardous moving parts or from the
impact of propelled parts.
!
!
Summary of Contents for C300 NP
